...
Skip to main content
Print

How to Create a Swap File on Linux

A swap file is extra virtual memory on your disk. When the RAM of your VPS fills up, Linux uses the swap, so processes such as your database are not killed. Swap is slower than real memory. If your server uses swap structurally, a larger VPS plan is the better solution.

Step 1: check whether there is already swap

swapon --show
free -h

Step 2: create the swap file

This creates a swap file of 2 GB. Adjust the size as desired:

fallocate -l 2G /swapfile
chmod 600 /swapfile
mkswap /swapfile
swapon /swapfile

Step 3: make the swap permanent

Add the swap file to /etc/fstab, so it is active again after a reboot:

echo '/swapfile none swap sw 0 0' >> /etc/fstab

Step 4: set swappiness

Swappiness determines how quickly Linux uses swap. For a server a low value such as 10 is usually best:

sysctl vm.swappiness=10
echo 'vm.swappiness=10' >> /etc/sysctl.conf

How large should swap be?

  • Up to 2 GB of RAM: as much swap as RAM.
  • More than 2 GB of RAM: 2 to 4 GB of swap is usually enough.

Related articles

Table of Contents